Okay, so you're tired of messy, exposed wires in your car or project, right? This braided sleeving is your fix. It's not your typical plastic tube – it's a flat, woven fabric (made from polyester and polyolefin) that you wrap around your wire bundle. Then, you hit it with a heat gun (keep it moving!). As it heats up, it shrinks to HALF its original diameter (that's the 2:1 ratio), forming a super tight, protective sleeve that looks pro. It's tough against abrasion, reduces noise from vibrating wires, and adds a nice, organized braided look that blends in with factory harnesses. It stays flexible, has no messy glue inside, and works in temps from -31°F to 284°F. This 20-foot roll is 1-1/8 inches wide before shrinking, so make sure your wire bundle is smaller than that to fit inside. Perfect for car audio installs, engine bay wiring, or any DIY electrical job where you want protection and a clean finish. Just heat, shrink, and admire your neat work.
