Doing a transmission seal job on a Ford Ranger and need to get that stubborn extension housing bushing out? This OTC tool (model 6913) is the professional way to do it. It's a simple but super effective puller made right here in the USA. You just slide the tool through the center of the old bushing, thread in the drive screw, and tighten it down. As you tighten, it pulls the bushing straight out without damaging the aluminum housing. It's a must-have if you're working on common Ford Ranger transmissions like the 4R44E, 4R55E, 5R55E, A4LD, C3, or T5OD. Beats trying to hammer it out or pry at it and risking a costly mistake. This is the same style as the old 308-070 tool. If you're a DIYer or a shop tackling these transmissions, this little tool saves a ton of frustration and time. Makes the job clean and easy.
