Is your RV’s slide room struggling to move or not moving at all? The motor might be worn out. This is a direct replacement in-wall slide out motor designed for Lippert (LCI) Schwintek in-wall slide systems. The key specification is the 500:1 high torque gear ratio, which matches the original part number 287298. (There’s also a 300:1 motor, part #236575, so check your old motor’s label carefully!). This 12-volt DC motor is what powers the gears that extend and retract your slide room smoothly and quietly. It’s a plug-and-play replacement: you’ll need to access the motor (usually behind an interior panel in the slide room), disconnect the old one, and connect this new one. It comes with the necessary mounting hardware and connectors as shown. Installing a new motor is often much simpler and cheaper than replacing the whole slide mechanism. Before you buy, it’s super important to confirm your RV’s slide system brand (Lippert Schwintek) and the exact part number or gear ratio (500:1) of your failed motor to get the correct match and get your slide room working smoothly again.
